Fastboot flashing lock failed reddit. Even with a complete system flash and wipe of data.

Fastboot flashing lock failed reddit FAILED (remote: 'Unrecognized command flashing lock') Upon rebooting, my device (surface duo 2) was only able to boot to the bootloader (no system, no recovery). I have enabled OEM unlock in dev settings like so, however when I attempt to flash the unlock token I get the following error: Hey, I have the same kind of device with this issue. Even with a complete system flash and wipe of data. Tinker at your I've booted into fastboot, and connected my phone, it shows up when I run fastboot devices, but trying either fastboot flashing lock or fastboot oem lock results in the same error (see below). If it is, try unlocking your bootloader again the official way. I just used the MSM tool to restore it back to stock, and now I'm trying to unlock the bootloader again. The issue is whenever I try to flash something onto the phone I get the following error : "FAILED (remote: Flashing Lock Flag is locked. If you're in the bootloader, cycle through to 'recovery mode', and then when the little android man is spilling his guts, hit the volume up button. If you're in the bootloader, cycle through to 'recovery mode', and then when the little android man is spilling his guts, hit the volume up button. Devices intended for retail should be shipped in the locked state (with get_unlock_ability returning 0) to ensure that attackers can't compromise the device by installing a new system or boot image. I've booted into fastboot, and connected my phone, it shows up when I run fastboot devices, but trying either fastboot flashing lock or fastboot oem lock results in the same error (see below). If it doesn't work, have you been able to enter recovery mode? Try sudo fastboot flashing lock. I have a T-Mobile OP8. I cannot relock the bootloader. . This is an problem because the bootloader only gets you access to fastboot commands, and the official recovery zip is only flashable over adb (which requires being in Hello. If OEM unlock was toggled on before it should work, then flash stock again. After a lot of experimenting, flashing, re-flashing, wiping etc. I've been trying to relock my bootloader all afternoon Why? I was on B121 with unlocked bootloader, TWRP and SU. I am guessing the bootloader is not unlockable, I think this is true for probably any device with this processor. That's it. You can follow the step-by-step guide and tutorial here. Is OEM unlock toggled in your settings screen? That is an option that must always be on if you intend on messing around with any device. Only lock your bootloader while running stock firmware, or else your device will be bricked! I entered fastboot by holding Volume Down + Power and got into it without problem, but when I tried to flash TWRP to install something else, I got the "FAILED (remote: 'Failed to load/authenticate boot image: Load Error')" and after checking, it seems that my bootloader has been re-locked! To lock the bootloader and reset the device, run the fastboot flashing lock command on the device. Perhaps from here you run fastboot commands that will successfully lock your bootloader. FAILED (remote: 'Unrecognized command flashing lock') fastboot flashing lock. I want to unlock bootloader of itel p33 (Couldn't found any custom recovery for this device) I tried adb fastboot option fastboot oem unlock I've been trying to relock my bootloader all afternoon Why? I was on B121 with unlocked bootloader, TWRP and SU. [OP8] Can you guys help me figure out why I can't flash my bootloader unlock token? Hi guys. From there you can navigate to something called fastboot mode. Please unlock it first!)" When I go to unlock $ fastboot flashing lock FAILED (remote: 'invalid android images, skip locking') fastboot: error: Command failed This seems to be related to an A/B signing mismatch. Hopefully this helps someone. It fails with. ' To relock your bootloader just run the command fastboot flashing lock. It will lock the bootloader, locking the bootloader wipe data and factory reset your phone so better to take backup first. My intention was to flash stock recovery, relock and update to B140. At some point Google changed some commands (like on the Google pixel) from OEM To 'fastboot flashing. The fix is to populate both slots with DivestOS. I got my hands on a reference sprd u-boot source code, which is not exactly labeled for this chipset but it seems to have a lot of things related to it. vndnhzl cxvwl ryzh esp bfox ndygp nalq yurxw runfs yzmmi